![]() The sessions were very unreliable (all <15s), picocom frequently terminated on zero bytes read, IO error or displays nothing at all. Using picocom to intercept the boot process, powercycling the router when I get corrupted / no text from uart (happed often) Tested my raspberry pi4's serial IO with another microcontroller 115.2k 8n1 - works fine. Setup and tested atftpd: able to serve tufax4200.bin fine. Hi there! I tried to flash openwrt 23.05.0-rc3 (r23389-5deed175a5) yesterday but did not get past step 2. It's probably not the right way, but if someone can explain what's wrong or not, that would be great. Taaaadddaaa it worked and the original firmware is back on it. Then I turned off the router and used the Asus recovery tool and installed it according to Asus' instructions. When it was in my boot loop and nothing worked, I turned off the router and tried a second one with the same result. ![]() You will see the follow, hit enter directly: Warning!! Erase Linux in Flash then burn new one. Then the dut will reboot,interrupt the autoboot process by pressing '2' when prompted.Ģ: Load System code then write to Flash via TFTP. (ip address: 192.168.1.66, subnet mask:255.255.255.0)ģ: Conect to the serial console, power on again, interrupt the autoboot process by pressing '4' when prompted. Set a static ip on the ethernet interface of your PC. Save the firmware to tftp server directory and rename to xĢ: Connect the PC with TFTP server to the AX4200. Unfortunately, it doesn't work that way because it's in the boot loop afterwards if you do it that way.ġ: Download the AX4200 firmware from ASUS official website.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |